These are the basic items needed to for the three fitting system -
BALLASTED - FULLY BONDED & MECHANICALLY ATTACHED FLAT ROOFING SYSTEMS
(see info page) Please call us if you are not sure when we will
be more than happy to assist you with your flat roof problem. EPDM the
perfect replacing flat roof felt alternative.
 |
EPDM Rubber Membrane
Rubber Sheet: 1.14 mm (045") Available in widths of 3, 6, 9, 12 & 15
metres wide Seamless one sheet membrane is suitable for residential and
commercial flat roof buildings |
 |
Geotextile Underlay
Acts as a Barrier between the substrate (felt flat roof or new flat roof
decking) and the EPDM. It is used with the mechanically attached and
ballasted systems. Old felt can be left intact if the roof is sound
condition |
 |
Roof Edge Trim
Provides a professional finish to the roof edges. It is important that
the EPDM is clamped firmly on the perimeter to guard against wind uplift |
 |
Weatherwise Adhesive
This is applied 100 mm in from the gutter edge and forms a non
setting base to which the ballast is held firmly. It prevents
the ballast from falling into the flat roof gutter during storms |
 |
Substrate Adhesive
Bonds the EPDM membrane to anything but itself like brick, wood, concrete or even a grp flat roof. Available in 20, 5 & 2.5 litres. 5 litres cover approx. 15 sq/m & 2.5 litres covers aprox 7.5 sq/m |
 |
Water Based Adhesive
Specially formulated to bond EPDM to new flat roof decking. Its slow cure time provides ample opportunity to achieve a 100% smooth finish. Available in containers of 5 litres to cover 20 - 25 sq/m and 2.5 litres to cover 10 - 12 sq/m |
 |
Seam Adhesive
Bonds EPDM to EPDM only. Used also to bond EPDM to raw rubber (uncured) and the anchor strip to EPDM. Available in 3.75 litre
containers.
|
 |
Uncured Rubber
For flat roof details like flat roof skylights, pipes and flat roof venrs etc. Because it is
uncured, it is malleable and can be stretched and shaped into
any form. Bonded with Seam adhesive. |
 |
Splice Cleaner
Used to prime the surface of EPDM when bonding to more EPDM used in
conjunction with seam adhesive
|
 |
Anchor Strips and Plates
(mechanically attached system) These strips are used to form a grid
which is then attached to the base. The EPDM membrane is then simply
adhered to the grid with Seam Adhesive. Supplied with 100 fixing discs
that take standard woodscrews. |
|